Preview

Advanced Engineering Research (Rostov-on-Don)

Advanced search

MODELING OF TOOL DEFORMATION OFFSETTING TO WORKPIECE IN TURNING

Abstract

Mathematical simulation of the elastic deformation offsettings of the cutting tool top and the workpiece in their contact point is considered. Algorithms and results of the identification of the model parameters for the case of linear turning are described.

About the Authors

Vilor L. ZAKOVOROTNIY
Don State Technical University
Russian Federation


Dinh Tung PHAM
Don State Technical University
Russian Federation


Xuan Chiem NGUYEN
Don State Technical University
Russian Federation


References

1. Sokolovskii A.P. Nauchnye osnovy tehnologii mashinostroeniya / A.P. Sokolovskii. – M.: Mashgiz, 1955. – 514 s. – In Russian.

2. Adaptivnoe upravlenie stankami / pod red. B.S. Balakshina. – M.: Mashinostroenie, 1973. – 688 s. – In Russian.

3. Kudinov V.A. Dinamika stankov / V.A. Kudinov. – M.: Mashinostroenie, 1967. – 360 s. – In Russian.

4. Zakovorotnyi V.L. Dinamika processa rezaniya. Sinergeticheskii podhod / V.L. Zakovorotnyi, M.B. Flek. – Rostov n/D: Terra, 2006. – 876 s. – In Russian.

5. Kanatnikov A.N. Lineinaya algebra / A.N. Kanatnikov, A.P. Krischenko. – M.: Izd-vo Mosk. gos. un-ta im. N.E. Baumana, 2002. – 336 s. – In Russian.

6. Bellman R. Vvedenie v teoriyu matric / R. Bellman. – M.: Nauka, 1969. – 639 s. – In Russian.


Review

For citations:


ZAKOVOROTNIY V., PHAM D., NGUYEN X. MODELING OF TOOL DEFORMATION OFFSETTING TO WORKPIECE IN TURNING. Vestnik of Don State Technical University. 2010;10(7):1005-1015. (In Russ.)

Views: 329


Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.


ISSN 2687-1653 (Online)