EFFECT OF SPINDLE SERVO DRIVE PROPERTIES ON DRILLING DYNAMICS OF DEEP PINHOLES
Abstract
Some issues on forming movement modeling when drilling deep holes with the dynamic link generated under cutting are considered. The results of the spindle frequency drift trajectories simulation in Matlab according to the parameters of the servo motor and process characteristics are presented. For the first time, metal drilling cut processes with the ever increasing section modulus determined by chip making are simulated. The phase path describing the forming movement dynamics under drilling deep holes with the increasing section modulus associated with chip making is exemplified. The phase portrait transformation depending on the servo motor parameters and the production process is shown. Recommendations on the motor parameters selection are given. They depend on the processing dynamic characteristics, and on the modulus effect determined by chip making.
About the Authors
Victor Petrovich LapshinRussian Federation
Ilya Andreyevich Turkin
Russian Federation
References
1. Zakovorotniy, V. L., Sankar, T. S., Bordachev, E. V. Sistema optimalnogo upravleniya protsessom glubokogo sverleniya otverstiy malogo diametra. [Optimal control system of pinhole deep drilling.] STIN, 1994, no. 12, pp. 9–15 (in Russian).
2. Zakovorotniy, V. L., Sankar, T. S., Bordachev, E. V. Sistema optimalnogo upravleniya protsessom glubokogo sverleniya otverstiy malogo diametra. [Optimal control system of pinhole deep drilling.] STIN, 1995, no. 1, pp. 12–18 (in Russian).
3. Zakovorotniy, V. L., et al. Modelirovaniye dinamicheskoy svyazi, formiruyemoy protsessom tocheniya, v zadachakh dinamiki protsessa rezaniya (skorostnaya svyaz). [Dynamic coupling simulation formed through turning process in cutting dynamic problems (high-velocity connection).] Vestnik of Don State Technical University, 2011, no. 2, pp. 137–146 (in Russian).
Review
For citations:
Lapshin V.P., Turkin I.A. EFFECT OF SPINDLE SERVO DRIVE PROPERTIES ON DRILLING DYNAMICS OF DEEP PINHOLES. Vestnik of Don State Technical University. 2013;13(5-6):125-130. (In Russ.) https://doi.org/10.12737/1290