NONUNIFORMITY DEFORMATION DURING ONESIDED METAL FLEW TO A DIE IMPRESSION
Abstract
The problem of appearing defects in the form of crack formation on some areas of forgings can be explained by considerable non-uniformity deformation occurred in these areas. To optimize solving the problem in we suggest the method of defining these possible destructive areas.
About the Authors
A.Z. ZHURAVLEV
Don State Technical University.
Russian Federation
Russian Federation
N.A. IVCHENKO
Don State Technical University.
Russian Federation
Russian Federation
E.A. EFREMOVA
Don State Technical University.
Russian Federation
Russian Federation
G.N. BACLAG
Don State Technical University.
Russian Federation
Russian Federation
V.V. КUZNECOW
Don State Technical University.
Russian Federation
Russian Federation
A.S. DUGINCEW
Don State Technical University.
Russian Federation
Russian Federation
References
1. Охрименко Я.М. Неравномерность деформации при ковке/Я.М.Охрименко, В.А.Тюрин. -М.: Машиностроение, 1969. -183 с.
2. Евстратов В.А. Теория обработки металлов давлением/В.А.Евстратов. -Харьков: Вища школа. Изд-во при Харьк. университете. 1981. -241 с.
3. Губкин С.И. Теория обработки металлов давлением/С.И.Губкин. -М.: ГНТИ, 1947. -532 с.
4. Перлин И.Л. Теория волочения/И.Л.Перлин. -М.: Металлургиз-дат, 1957. -424 с.
5. Журавлёв А.З. Основы теории штамповки в закрытых штампах/А.З.Журавлёв. -М.: Машиностроение, 1973. -221 с.
6. Надаи А. Пластичность./А.Надаи. -М.: Машиностроение, 1936. -196 с.
Review
For citations:
ZHURAVLEV A., IVCHENKO N., EFREMOVA E., BACLAG G., КUZNECOW V., DUGINCEW A. NONUNIFORMITY DEFORMATION DURING ONESIDED METAL FLEW TO A DIE IMPRESSION. Vestnik of Don State Technical University. 2007;7(4):451-458. (In Russ.)
Views:
379
Email this article 