PROCESS FLOWSHEET OF GEAR PART CUTTING ON VIBRO-ULTRASONIC EQUIPMENT
Abstract
An effective part cutting technique with the ultrasonic generators is offered. The pilot designs of the working chambers are developed. The tests are run, the results are analyzed.
References
1. Babichev A.P. Osnovy` vibracionnoj texnologii / A.P. Babichev, I.A. Babichev. – 2-e izd., pererab. i dop. – Rostov n/D: Izdatel`skij centr DGTU, 2008. – 694 s. – In Russian.
2. Babichev A.P. Vibracionnaya obrabotka detalej / A.P. Babichev. – 2-e izd. – M.: Mashinostroenie, 1974. – 136 s. – In Russian.
3. Volosatov V.A. Rabota na ul`trazvukovy`x ustanovkax: ucheb. posobie dlya podgotovki rabochix na proizvodstve / V.A. Volosatov. – M.: Vy`ssh. shk., 1979. – 191 s. – (Proftexobrazovanie. Ul`trazvukovaya obrabotka materialov). – In Russian.
4. Markov A.I. Ul`trazvukovaya obrabotka materialov / A.I. Markov. – M.: Mashinostroenie, 1980. – 237 s. – (B-ka texnologa). – In Russian.
5. Ul`trazvukovoe rezanie / L.D. Rozenberg [i dr.]. – M.: Izd-vo AN SSSR, 1962. – In Russian.
Review
For citations:
Vyalikov I.L. PROCESS FLOWSHEET OF GEAR PART CUTTING ON VIBRO-ULTRASONIC EQUIPMENT. Vestnik of Don State Technical University. 2012;12(1-1):109-113. (In Russ.)
Views:
362
Email this article 