HOB BACKOFF FOR GEAR MACHINING WITH NORMAL ELLIPTIC PROFILE
Abstract
The equations of the hob relief, based on the earlier dependences of the section coordinates of the elliptic tooth-wheel profile, and the equations of the hob cutting profile are defined.
About the Authors
Anatoly A. Ryzhkin
Don State Technical University
Russian Federation
Russian Federation
Vladimir V. Zotov
Don State Technical University
Russian Federation
Russian Federation
Denis V. Moiseyev
Don State Technical University
Russian Federation
Russian Federation
References
1. Ry`zhkin A.A. Opredelenie koordinat bokovy`x storon zub`ev kolyos s e`llipticheskim profilem / A.A. Ry`zhkin [i dr.] // Vestn. Donsk. gos. texn. un-ta. – 2009. – T. 9. – # 4. – S. 284–295. – In Russian.
2. Ry`zhkin A.A. K voprosu analiticheskoj ocenki profilya e`llipticheskogo zuba kolesa / A.A. Ry`zhkin, D.V. Moiseev // Vestn. Donsk. gos. texn. un-ta. – 2009. – T. 9. – # 4. – S. 172–186. – In Russian.
3. Ry`zhkin A.A. Opredelenie profilya chervyachnoj frezy` dlya izgotovleniya zubchaty`x kolyos e`llipticheskogo profilya / A.A. Ry`zhkin [i dr.] // Vestn. Donsk. gos. texn. un-ta. – 2010. – T. 10. – # 5. – S. 731–734. – In Russian.
4. Inozemcev G.G. Profilirovanie chervyachny`x frez dlya peredach Novikova / G.G. Inozemcev, E.P. Sergienko. – Saratov: Privolzh. knizhnoe izd-vo, 1968. – 143 s. – In Russian.
5. Grubin A.N. Zuborezny`j instrument / A.N. Grubin, M.B. Lixcier, M.S. Poloczkij. – M.: Mashgiz, 1946. – Ch. II. – In Russian.
Review
For citations:
Ryzhkin A.A., Zotov V.V., Moiseyev D.V. HOB BACKOFF FOR GEAR MACHINING WITH NORMAL ELLIPTIC PROFILE. Vestnik of Don State Technical University. 2011;11(8-1):1210-1216. (In Russ.)
Views:
417
Email this article 