Preview

Advanced Engineering Research (Rostov-on-Don)

Advanced search

MODELING AND IDENTIFICATION OF INERTIAL AND DISSIPATIVE PROPERTIES OF SUBSYSTEMS OF CUTTING TOOL AND WORKPIECE IN TURNING

Abstract

The question of mathematical simulation and identification of the dynamic subsystems parameters of the tool and workpiece when investigating the cutting process is considered.

About the Authors

Vilor L. ZAKOVOROTNIY
Don State Technical University
Russian Federation


Dinh Tung PHAM
Don State Technical University
Russian Federation


Xuan Chiem NGUYEN
Don State Technical University
Russian Federation


References

1. Kudinov V.A. Dinamika stankov / V.A. Kudinov. – M.: Mashinostroenie, 1967. – 359 s. – In Russian.

2. Zakovorotnyi V.L. Dinamika processa rezaniya. Sinergeticheskii podhod / V.L. Zakovorotnyi, M.B. Flek. – Rostov n/D: Terra, 2006. – 876 s. – In Russian.

3. Zakovorotnyi V.L. Modelirovanie deformacionnyh smeschenii instrumenta otnositel'no zagotovki pri tochenii / V.L. Zakovorotnyi, Tung Fam Din', T'em Nguen Suan // Vestn. Donsk. gos. tehn. un-ta. – 2010. – T.10. – №7. – S.1005-1015. – In Russian.


Review

For citations:


ZAKOVOROTNIY V., PHAM D., NGUYEN X. MODELING AND IDENTIFICATION OF INERTIAL AND DISSIPATIVE PROPERTIES OF SUBSYSTEMS OF CUTTING TOOL AND WORKPIECE IN TURNING. Vestnik of Don State Technical University. 2010;10(8):1165-1178. (In Russ.)

Views: 368


Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.


ISSN 2687-1653 (Online)