MODELING AND IDENTIFICATION OF INERTIAL AND DISSIPATIVE PROPERTIES OF SUBSYSTEMS OF CUTTING TOOL AND WORKPIECE IN TURNING
Abstract
The question of mathematical simulation and identification of the dynamic subsystems parameters of the tool and workpiece when investigating the cutting process is considered.
About the Authors
Vilor L. ZAKOVOROTNIYRussian Federation
Dinh Tung PHAM
Russian Federation
Xuan Chiem NGUYEN
Russian Federation
References
1. Kudinov V.A. Dinamika stankov / V.A. Kudinov. – M.: Mashinostroenie, 1967. – 359 s. – In Russian.
2. Zakovorotnyi V.L. Dinamika processa rezaniya. Sinergeticheskii podhod / V.L. Zakovorotnyi, M.B. Flek. – Rostov n/D: Terra, 2006. – 876 s. – In Russian.
3. Zakovorotnyi V.L. Modelirovanie deformacionnyh smeschenii instrumenta otnositel'no zagotovki pri tochenii / V.L. Zakovorotnyi, Tung Fam Din', T'em Nguen Suan // Vestn. Donsk. gos. tehn. un-ta. – 2010. – T.10. – №7. – S.1005-1015. – In Russian.
Review
For citations:
ZAKOVOROTNIY V., PHAM D., NGUYEN X. MODELING AND IDENTIFICATION OF INERTIAL AND DISSIPATIVE PROPERTIES OF SUBSYSTEMS OF CUTTING TOOL AND WORKPIECE IN TURNING. Vestnik of Don State Technical University. 2010;10(8):1165-1178. (In Russ.)