Issue | Title | |
Vol 18, No 4 (2018) | Effect of recuperative volume parameters on dynamic characteristics of pneumatic drive underbraking | Abstract PDF (Eng) similar documents |
A. N. Sirotenko, S. A. Partko, Wael Salloum | ||
"... of energy saving in pneumatic drives under the organization of backpressure braking. The use of recuperative ..." | ||
Vol 15, No 4 (2015) | Study on positioning accuracy of automated pneumatic drive with an outer brake | Abstract similar documents |
The Anh Dao, Valentin S. Sidorenko, Denis D. Dymochkin | ||
"... The work objective is to introduce a design of the automated pneumatic drive (APD) with an external ..." | ||
Vol 23, No 3 (2023) | Investigation of Dynamic Characteristics of an Automated Position Long-Stroke Pneumatic Actuator of Fabrication System | Abstract PDF (Eng) similar documents |
D. A. Korotych, V. S. Sidorenko, S. P. Prikhodko | ||
"... ; diameters of the pipeline, the pneumatic cylinder piston and the braking device; length of the stroke ..." | ||
Vol 17, No 4 (2017) | Dependence of energy-speed characteristics of pneumatic drive on initial parameters of additional volume under counterpressure braking | Abstract similar documents |
Andrey N. Sirotenko, Svetlana A. Partko, Bakir Ala Saed | ||
"... link of the pneumatic drive. The counterpressure braking technique is of interest from the point ..." | ||
Vol 25, No 1 (2025) | Using Surrogate Models in the Construction of a Pareto-Optimal Positioning Electropneumatic Actuator with Discrete Pneumatic Valves | Abstract PDF (Eng) similar documents |
M. O. Sheykin, S. N. Cherkasskikh, D. V. Shilin, V. V. Fedenkov | ||
"... Introduction. Pneumatic actuators are widely used in industry due to their reliability, simplicity ..." | ||
Vol 10, No 4 (2010) | ANALYSIS OF BRAKING MODES WITH APPLICATION OF HYDROSHOCK ABSORBERS FOR MECHANISMS OF INCREASED OPERATION SPEED | Abstract similar documents |
Maria S. KILINA, Vladimir A. TCHERNAVSKIY | ||
"... Braking modes with application of hydroshock-absorbers for MECHANISMS OF INCREASED OPERATION SPEED ..." | ||
Vol 11, No 9 (2011) | Исследование рекуперативной гидромеханической системы стенда испытаний объёмных гидромашин | Abstract similar documents |
Alexander T. Rybak, Viktor P. Zharov, Mikhail V. Ustyantsev, Alexander G. Yefimenko | ||
"... Приводятся основные теоретические и экспериментальные результаты исследований рекуперативной ..." | ||
Vol 11, No 7 (2011) | UPDATING OF PNEUMATIC FEED AS FACTOR OF SEED RATE INCREASE | Abstract similar documents |
Valeriy V. Dolzhikov | ||
"... The design and working conditions of the pneumatic disk feeds which permit to improve the cropping ..." | ||
Vol 12, No 7 (2012) | SIMULATION OF GRAIN PILE SEPARATION IN VERTICAL PNEUMATIC PASSAGE | Abstract similar documents |
Yury I. Yermolyev, A. V. Butovchenko, A. A. Doroshenko, S. V. Belov | ||
"... The methodology and grain pile pneumatic separation parameters in the vertical pneumatic passage ..." | ||
Vol 11, No 4 (2011) | ASSESSMENT OF OPERATION BASIC TRENDS OF SCREEN TIER-PNEUMOSEPARATOR OF AIR-AND-SCREEN CLEANER SUBSYSTEMS | Abstract similar documents |
Yuri I. Ermolyev, Vasily D. Shaforostov, Andrey V. Butovchenko, Igor E. Priporov | ||
Vol 20, No 1 (2020) | Brake rigging dynamic simulation under braking on a track section with irregularities (the case of a passenger car) | Abstract PDF (Eng) similar documents |
I. A. Yaitskov, V. V. Kosarevskii | ||
"... of a passenger car under braking on a track section with irregularities. The work objectives include ..." | ||
Vol 12, No 6 (2012) | MOISTURE CRYSTALLIZATION RISK REDUCTION IN PNEUMATIC SYSTEMS THROUGH SPIRIT INSTALLATIONS APPLICATION | Abstract similar documents |
Leonid F. Ripol-Saragosi | ||
"... The issues on the elimination mechanisms of the rolling stock pneumatics overfreezing using ..." | ||
Vol 10, No 4 (2010) | VIBRATION SIMULATION OF TECHNOLOGICAL MACHINE BODY IN THE DYNAMIC BRAKING MODE OF ASYNCHRONOUS MACHINE WITH FREQUENCY CONTROL | Abstract similar documents |
Nikolay F. KARNAUKHOV, Julia V. PUDOVA, Maxim N. FILIMONOV | ||
Vol 16, No 1 (2016) | Braking mode simulation of induction motor of variable-frequency drive using stator current harmonics ** | Abstract similar documents |
Nikolay F. Karnaukhov, Maxim N. Filimonov, Dmitry A. Statovoy, FelixVenegas V. Bonilla | ||
"... ) by the mathematical modeling method, in particular, in the two-current mode of the dynamic braking considering the 5th ..." | ||
Vol 14, No 2 (2014) | MODELING OF MILLED STRAW HEAP SEPARATION IN AIR-FLOW CLASSIFICATOR WITH TWO PNEUMATIC DUCTS | Abstract similar documents |
Yury Ivanovich Yermolyev, Sergey Vladimirovich Belov, Igor Alexandrovich Ivashchenko, Roman Evgenyevich Fomenko | ||
"... is described. Each pneumatic duct is segmented into blocks with various probabilistic characteristics ..." | ||
Vol 16, No 2 (2016) | Modeling of milled straw heap separation in air-flow classificator with three pneumatic ducts | Abstract similar documents |
Yury I. Yermolyev, Artem A. Doroshenko, Sergey V. Belov | ||
"... . The work objective is to identify patterns of the air separation using three pneumatic ducts with a linkage ..." | ||
Vol 12, No 4 (2012) | POSITIONING DYNAMICS OF DRIVE GEARS WITH HYDROABSORBER | Abstract similar documents |
Vyacheslav I. Grishchenko, Maria S. Kilina, Vladimir A. Chernavskiy | ||
"... Kinds of liquid dashpots, braking modes are considered. The improvement of the drive dynamic ..." | ||
Vol 7, No 2 (2007) | HYDRAULIC BATTERY AS ELEMENT OF THE HYDRAULIC-MECHANICAL SYSTEM AND ITS DYNAMIC MODEL | Abstract similar documents |
A.T. RYBAK | ||
"... to dynamic model of the hydraulic battery with pneumatic spring and its brought three-dementional acerbity. ..." | ||
Vol 21, No 1 (2021) | Inverse analysis method for mathematical modeling of hydrodynamic ballast in a drilling rig | Abstract PDF (Eng) similar documents |
I. R. Antypas, A. G. Dyachenko, B. I. Saed | ||
"... analysis method, the effect of some performance indicators on the braking torque of the hydraulic brake ..." | ||
Vol 10, No 1 (2010) | SUBSTANTIATION OF GRAPHICAL METHOD OF TOOTH SPACE SHAPING FOR THE WHEEL WITH ASYMMETRIC PROFILES | Abstract similar documents |
P. A. KARGIN | ||
"... with large asymmetry of profiles suitable for construction of self-braking tooth gear drives of load-lifting ..." | ||
Vol 15, No 4 (2015) | Discharge-pulse compression of composite materials | Abstract similar documents |
Stanislav V. Neskoromniy, Sergey V. Lemeshev, Stanislav O. Ageyev, Evgeny L Strizhakov | ||
"... - pneumatic press, magnetic hammer -are analyzed. A compatible scheme of the pulse compression process ..." | ||
Vol 17, No 3 (2017) | Controllable vibration of mobility links of production mechanism | Abstract similar documents |
Nikolay F. Karnaukhov, Maxim N. Filimonov, Roman S. Mironenko | ||
"... of the mobile links in the PM guides under the starting-braking AM modes. Materials and Methods. To solve ..." | ||
Vol 19, No 3 (2019) | Theoretical background of hydraulic drive control system analysis for testing piston hydraulic cylinders | Abstract PDF (Eng) similar documents |
A. T. Rybak, I. K. Tsybriy, S. V. Nosachev, A. R. Zenin | ||
"... tests. At that, various braking devices (mechanical, electric, hydraulic, etc.) are used for strength ..." | ||
Vol 19, No 4 (2019) | Ensuring of the industrial robot link motion accuracy parameters in the low-speed zone | Abstract PDF (Eng) similar documents |
N. F. Karnaukhov, D. A. Smyatsky, M. N. Filimonov, K. I. Rudnev | ||
"... zone. The random character of friction forces changes in the implementation process start-braking modes ..." | ||
Vol 25, No 1 (2025) | Investigation of the Optimal Vacuum Depth Created by an Ejector Depending on the Value of the Supply Pressure | Abstract PDF (Eng) similar documents |
S. I. Savchuk, E. D. Umerov, A. U. Abdulgazis | ||
"... and are essential pneumatic devices. An important characteristic of a vacuum ejector is the vacuum depth it creates ..." | ||
1 - 25 of 25 Items |
Search tips:
- Search terms are case-insensitive
- Common words are ignored
- By default articles containing any term in the query are returned (i.e., OR is implied)
- Make sure that a word exists in an article by prefixing it with +; e.g., +journal +access scholarly academic
- Combine multiple words with AND to find articles containing all terms; e.g., education AND research
- Exclude a word by prefixing it with - or NOT; e.g., online -politics or online NOT politics
- Search for an exact phrase by putting it in quotes; e.g., "open access publishing". Hint: Quoting Chinese or Japanese words will help you to find exact word matches in mixed-language fields, e.g. "中国".
- Use parentheses to create more complex queries; e.g., archive ((journal AND conference) NOT theses)